HOW TO SET POSTS IN CONCRETE dig a hole fix a pole

Putting posts in the ground is an important step in building a fence, and pouring cement into the holes will keep your posts sturdy and protected. After digging 

Step 6. Mix a batch of quick-setting concrete in a bucket and pour it into the post hole, while an assistant holds the post steady. Fill the post hole with concrete to a point about 2 or 3 inches from the top. Hold the post in place for 10 to 20 minutes while the concrete hardens. Advertisement.

Most use concrete to create leverage. The main reason is the post length of choice for fence companies is often a 4″ x 4″ x 8′. As a result, the fence post is only two feet in the ground on a six-foot in height wood fence. Hence the use of concrete.

Set the mailbox post in the hole. If you need to lengthen your post, screw a 4×4 block of wood, cut to the length you desire, to the bottom of the post. Pour dry concrete mix into the hole. Most mailbox post installations require a 60 lb. bag of dry concrete. Pour a little more water on top of the concrete mix.

Photo 1: Start with a pilot hole. Dig a "pilot hole" the same diameter as the auger around the stake that marks the center of the hole. That'll keep the auger tip from wandering when you start the post hole auger. Operating a power auger calls for eye and hearing protection, as well as gloves and sturdy boots.

Pull Wooden Fence Posts Set in Concrete WITH NO DIGGING!: I wanted to post this to maybe help someone save a little time if they ever need to replace a fence, which has wooden posts that are set in concrete, and doesn't want to have to dig them out by hand.Here's the

The installer walks up to a post hole, tosses in a bag's worth of dry concrete mix, adds a little water on top and claims it will set on its own below grade with the moisture from the ground. So, the questions I get is 'that the proper way to do it?'. The short answer is 'no'. Mixed Concrete in a Fence Post Hole

I've had to dig out old concrete which was supporting a fence post. The original post had lots of concrete, so the hole is massive, far too big to realistically refill with concrete. How can I reuse this hole to erect a new fence post? It's a 6 foot panel fence in a windy area, so the post needs to be secure. I've got an 8 foot post to allow 2

A wire is inserted around the post for concrete reinforcement, while pieces of brick should fix the pole. This is to prevent the ultimate disaster of a pole

The concrete will harden within a few hours, but no heavy load should be placed on it until, at least, over night. If for any reason, one of the posts is not plumb, you can dig out around the concrete base to enlarge the hole. Shift the post into plumb and then add more concrete to fill the hole. Brace the post and allow to concrete to cure.

Square A Pole Barn. Use batter boards and mason lines to form the outline of the building dimensions. Mason lines should be about 12″ above grade. Posts are set 1 1/2″ inside the actual building dimension to leave room for the girts that are nailed to the outside perimeter of the posts (unless your construction technique will incorporate